Preparation before turn on the CNC shearing machine

1. The CNC shearing machine operator must be familiar with the main structure, performance, and use of the shearing machine.

2. Check whether the switch is in good condition, whether the buttons of the control cabinet and the console are in good condition, and whether the components are loose.

3. Check whether the tool is installed properly, whether it is loose, inclined, or debris.

4. Check for looseness, damage, or abnormality of each operating mechanism.

5. Check that there are no objects around and inside the machine that hinder the operation of the machine.

6. Add oil to each lubrication point.

Steps to turn on the CNC shearing machine

1. Start the oil pump and turn on the power.

2. Press the motor start button.

3. Wait a few minutes for the motor to fully enter the running state.

4. Turn the manual switch to the single position, test the cutting manually, and confirm that it is normal.

5. Adjust the blade gap according to the thickness of the material to be cut.

6. Adjust the profiling or fixture according to the width of the material to be cut.

7. Perform 1,3 idle strokes first, and then perform shearing work after normal.

8. Put the products to be cut according to the process requirements.

9. Step on the foot switch to cut the product.

Precautions

1. The machine tool is suitable for cutting various steel plates, copper plates, aluminum plates and non-metallic material plates whose material thickness is the rated value of the machine tool, and must be materials free of hard marks, welding slag, slag inclusions, and welds, and excessive thickness is not allowed.

2. When picking and placing the product, it should be carried out after it has risen and stabilized, and pay attention to the knife sliding down and hurting hands.

3. It is not allowed to cut laminated sheets, trim the edges of raw sheets, or cut narrow sheets and short sheets that are not tightly compressed.

4. The cutting edge of the blade should be kept sharp. If the cutting edge becomes dull or cracked, it should be replaced in time.

5. When cutting, the pressing device should firmly press the sheet, and it is not allowed to cut without being tight.

6. The equipment must be completely cut off before maintenance can be carried out.

7. Clean the oil around the equipment in time to prevent slipping.

8. It is forbidden to use percussion to tighten the stopper or adjust the blade gap. When adjusting the gap between the guide rail and the knife-edge, stop the machine before proceeding. It is forbidden to enter the cutting area by hand or pick up and pick up materials by hand during the working process.

After turn off the CNC shearing machine

1. Press the motor stop button.

2. Turn off the oil pump.

3. Check that the operation switches are not working.

4. Clean up the margins, residues, and sundries inside and outside the machine to ensure cleanliness.

5. Organize and clean the working environment and confirm cleanliness.

Maintenance

1. Clean up and clean the inside and outside of the machine every day before starting the machine to ensure that there is no debris or oil.

2. Check for oil leakage every day.

3. Lubricate the machine every day before starting it.

4. Frequently check whether the bolts and parts of the machine are loose, damaged, or displaced, and tighten and repair them in time.